Andersen windows and patio doors may be stored for later usage following the guidelines below. Andersen recommends finishing the interior wood before storing the product for long periods of time. Any damage as a result of not properly finishing a product is not covered under the terms of the Andersen® Owner-2-Owner® Limited Warranty .

Andersen® Windows and Doors

Proper Storage Guidelines

Follow the steps below to maintain the quality of the product that is being stored.

Inspect the door or window for any visible damage or defects upon receipt.

When moving doors and windows, lift and carry, do not drag.

If the product must be stored before installation, store it on a level surface in a dry, well-ventilated area. The relative humidity of the storage area should not exceed 50%.

Protect unfinished windows and doors from dirt, water and abuse. All window and patio door units must be finished or sealed or suitably protected no later than 14 days after arriving at the job site, or before storing prior to installation. See Staining Unfinished Wood Surfaces. Do not store unfinished wood products for any extended period of time.

Doors and windows should be handled with clean hands and equipment. Follow appropriate handling warnings in installation guides.

Do not store flat or on the side edge, finished wood (painted or stained/sealed) units should be stored upright.

Finish unassembled unfinished gliding patio doors and MultiGlide™ doors prior to installation. Some surfaces are not accessible after installation. For all other products, finish all wood surfaces immediately after installation. Some wood surfaces are hidden from view but will require proper finishing. Unfinished wood will deteriorate, discolor, and could bow or split.

Do not stain or paint weatherstrip, silicone beads, vinyl, glass or hardware.

Do not expose unfinished doors or windows to excessive heat, extreme dryness, high humidity, direct sunlight, or sudden changes in temperature.

Do not install unfinished doors and windows into a building before the drywall, wet plaster, texture, or cement work has been completed and dried.

For insect screen storage, see Proper Removal and Storage of Andersen® Insect Screens.

©2024 Andersen Corporation. All rights reserved.